✔ How To Replace A Blower Motor Resistor In A Jeep Liberty

How To Replace A Blower Motor Resistor In A Jeep Liberty

- July 13, 2017

In this video were going to show you how to replace the blower motor resistor on this 2006 jeep liberty. The blower motor resistor is located under the front dash on the passenger side of the truck.

15 Minutes Jeep Liberty Cooling Fan Motor Replacement 5

Blower Motor Resistor How It Works Symptoms Problems

Wells Front Hvac Blower Motor Resistor Fits 2008 2012 Jeep Liberty Commander

This repair is super easy and most folks can get it done in the time it takes to eat a hamburger.

How to replace a blower motor resistor in a jeep liberty. On high it bypasses the resistor for maximum speed. How to replace a blower resistor on a jeep liberty. There might be a plastic cover over it but it will have a 3 or 4 wire connector plugged into it.

I did drop one screw which i rarely do and a 7mm socket on the two screw removes the bottom air vent tray where the dropped screw will land. Start off by opening your glove box. But on low or medium speeds the resistor slows down the blower motor.

It should be located on the black box under the dash on the passenger side. When the resistor goes out the blower motor will only work on high. That sounds like the blower motor resistor.

The only items that youre going to need include a 90 degree pick an 8mm socket and a ratchet. It is a fairly simple job to replacemaybe 15 minutes. Best to remove and install plug with resistor removed from the installed location.

Replacing the blower motor resistor on your jeep liberty may be necessary if the hvac blower motor has stopped working in all but one speed. In this episode of the car doctor we replace the hvac blower motor in a jeep liberty. 8mm is the size of the socket for the plug screws.

Your blower motor resistor is located right here. This video demonstrates how to determine if your blower motor resistor is bad and how to replace it. The blower motor resistor is located under the front dash on the passenger side of the truck.

Push in on the sides and then pull the glove box down. It is a fairly simple job to replacemaybe 15 minutes. The resistor limits the amount of electrical current that is fed to the motor causing the motor to run faster or slower respectively.

It is an inexpensive part and easy to replace. If your vents will only work on the higher speeds then your resistor is likely bad.